Wow. I didn't know the BDT-220 could be controlled via IP, is there a protocol sheet somewhere? 
-Thom
Thom - here's the command set for the currently available Panasonics. Basically if the device has an iOS or Android App then you can be sure it's IP controllable. Uplink has a setup that allows him
to sit in the middles between the App and the device and observe whatever codes/protocol is in use. However in this case I found most of the codes via Google. We then just verified them with Uplinks 'man in the middle' rig;
Host: An IP address specific to your device. I went with a static address 192.168.1.201
Port: 80
HTTP POST as follows:
POST /WAN/dvdr/dvdr_ctrl.cgi? HTTP/1.1
User-Agent: MEI-LAN-REMOTE-CALL
Host: 192.168.1.105
Content-Length: [length]
cCMD_RC_[command].x=100&cCMD_RC_[command].y=100
Where you would replace [command] and [length] with the following depending on the action needed:
NOTE: Please note that STOP does not work on my DMP-BDT110 and I am looking for a command for the Display button. Also, if anyone knows of any Status commands, that would be nice to know as well.
Action [command] [length]
POWER POWER 39
OPEN/CLOSE OP_CL 39
1 (@.) 1D 33
2 (ABC) 2D 33
3 (DEF) 3D 33
4 (GHI) 4D 33
5 (JKL) 5D 33
6 (MNO) 6D 33
7 (PQRS) 7D 33
8 (TUV) 8D 33
9 (WXYZ) 9D 33
0 (-,) 0D 33
* (CANCEL) CLEAR 39
# ([_]) SHARP 39
SKYPE SKYPE 39
3-D 3D 33
AUDIO AUDIOSEL 45
NETFLIX NETFLIX 43
REWIND << REV 35
FAST FWD >> CUE 35
STOP STOP 37
PAUSE PAUSE 39
PLAY > PLAYBACK 45
REPLAY < SKIPREV 43
SKIP SKIPFWD 43
STATUS DSPSEL 41
EXIT EXIT 37
POP-UP MENU (TOP MENU) TITLE 39
VIERA CAST V_CAST 41
HOME MLTNAV 41
UP UP 33
DOWN DOWN 37
LEFT LEFT 37
RIGHT RIGHT 39
OK SELECT 41
SUBMENU MENU 37
RETURN RETURN 41
RED RED 35
GREEN GREEN 39
BLUE BLUE 37
YELLOW YELLOW 41
PIP P_IN_P 41
OSD OSDONOFF 45
(swipe in CW circle) SHFWD2 41
(swipe in CCW circle) SHREV2 41
