Fibaro Dimmer Module - FGD-211 - Dianemo

[mardibloke]

With z-wave Fibaro FGD-211 dimmer module,  *not* included in z-wave network.  The light switch, 1 press to switch on, 1 press to switch light off, hold switch to set dimmer level - works fine/as expected.

As soon as I include the z-wave module in my Linuxmce/Dianemo z-wave network,  the light switch can no longer be used to turn light off.It does switch light on and can set dimmer level.  

Control from Linuxmce orbiters works as expected, allowing off/on/level.

Exclude it from z-wave network again, and switch works fine, allowing to switch off the light.

Any ideas/things to check?

[mardibloke]

Any advice at all appreciated, have tried everything I can think of, reset/recreated my z-wave network, checked wiring, tried another new Dimmer module, and exhausted google.

[hari]

meet me on irc.

[totallymaxed]

Any advice at all appreciated, have tried everything I can think of, reset/recreated my z-wave network, checked wiring, tried another new Dimmer module, and exhausted google.

Hmmm... we have some Fibaro modules here. i will see if we can get them installed to so we can see if we can reproduce this.

Andrew

[daballiemo]

Any progress on this? Would like to know as I am about to replace a number of Jung dimmers by the fibaro ones.

Tia

Han

[mardibloke]

Sorry I didn't get in touch with Hari and try to sort this out.

I suspect it may work with Linuxmce,  but for Dianemo some of the config panels I appear to need are not available to me.

Will get in touch with Hari in the near future and try again.

[mardibloke]

Now trying with an MK LRC14 remote....

Getting same issue, that switch does not function as expected once device added to z-wave network

Reset all zwave network,  and have added devices back in.

Anyone played with Fibaro and Dianemo/Linuxmce?

[mardibloke]

From the Dimmer Module guide: http://mojefibaro.cz/static/materialy/Advanced%20Users%20Guide%20ver%20102beta.pdf

Section 3.1.3 3.1.3 Example Configuration Parameters

I believe I need to set Parameter 14:

Parameter 14
Wall Switch type - mono-stable (press switch) or bi-stable
Default setting:
mono-stable


Any ideas how I set a z-wave parameter using Dianemo / Linuxmce ?