changing device template ir codes

[rperre]

I added a device for my Philips LCD tv and learned the IR codes (actually got the discretes and manually entered them). I forgot however to add the volume commands, so i go into webadmin templates, select my new template... add the volume control and tell it to "learn code"....

A new window opens and immediately another one that says "code learned"

no matter what i try, it keeps doing this, can i get around this?

Thanks,

Richard

[Techstyle]

Last night I was learning codes for one of my new templates and did not see this same issue. The code learned window would only come up once a new code was sent.

Is there a lot of background IR that your USB UIRT (or whatever) is picking up?

When did you last update?  My build is from 18th june

[rperre]

Techstyle thanks for the reaction.

It's not happening when first creating the device, everything works fine, it learns the codes, etc..

Now i have created a template, saved it, media wizard it, etc... but i forgot some IR codes i needed. So when i go through "device templates" to change/add ir codes it will give me the above behaviour. I guess i can just make a new template again, but that's not very "clean" imo plus it looks like a bug.

Richard

[Techstyle]

I created my template a few days a go have been adding extra bits of IR codes to it over the last few days, both by manual pasting and by learning.
This issue is not on my system.

[rperre]

ok, thank you, wanted to make sure.

I'll probably will have to do a re-install, because webadmin is not behaving anymore, i mean at all, can barely get into the website and if i click templates it takes forever to load, or will fail to load.

Richard