LinuxMCE Forums
General => Users => Topic started by: rperre on June 24, 2010, 05:54:33 am
-
I added a device for my Philips LCD tv and learned the IR codes (actually got the discretes and manually entered them). I forgot however to add the volume commands, so i go into webadmin templates, select my new template... add the volume control and tell it to "learn code"....
A new window opens and immediately another one that says "code learned"
no matter what i try, it keeps doing this, can i get around this?
Thanks,
Richard
-
Last night I was learning codes for one of my new templates and did not see this same issue. The code learned window would only come up once a new code was sent.
Is there a lot of background IR that your USB UIRT (or whatever) is picking up?
When did you last update? My build is from 18th june
-
Techstyle thanks for the reaction.
It's not happening when first creating the device, everything works fine, it learns the codes, etc..
Now i have created a template, saved it, media wizard it, etc... but i forgot some IR codes i needed. So when i go through "device templates" to change/add ir codes it will give me the above behaviour. I guess i can just make a new template again, but that's not very "clean" imo plus it looks like a bug.
Richard
-
I created my template a few days a go have been adding extra bits of IR codes to it over the last few days, both by manual pasting and by learning.
This issue is not on my system.
-
ok, thank you, wanted to make sure.
I'll probably will have to do a re-install, because webadmin is not behaving anymore, i mean at all, can barely get into the website and if i click templates it takes forever to load, or will fail to load.
Richard