Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - edbroni

Pages: [1]
Users / Stream and TV inclusion by ethernet
« on: September 22, 2011, 06:02:46 am »

   I have my core installed in a notebook. My TV is connected by ethernet cable. So I followed the steps in wiki and can´t include my TV to be controlled over ethernet. Is this possible?
   Can I share or stream movies and musics over my network to be receive in the TV?


Installation issues / Some problem - installation
« on: September 19, 2011, 03:07:37 pm »

   I'm having some problems to do LinuxMCE works with my configuration:

Notebook Core2Duo T5500
Video: Intel 945 (using driver i810)
Sound: Intel HDA (using driver intel)
Home automation: Zwave (dimmers and switchs) with an AeonLabs Zstick S2
    First problem: I can't use the UI2 with overlay just UI1 and I need switch in /etx/X11/xorg.conf   "Linear alloc" to value "8160" by first time appear other value. Isn't supported my video board by LinuxMCE?
    Second: No sound after install LinuxMCE. When I installed Kubuntu everything was ok, but after no.
    Third: I can't include the Leviton VRCS2 - 2 room controll - Is this supported by LinuxMCE?



Developers / Help in Ruby and GSD
« on: March 18, 2011, 03:44:45 am »

   I´m new in the forum. I´m also new in LinuxMCE, I installed the system two month ago. I read many posts but not found a answer to my question.
   I´m trying to build a home automation using a PLC with a ethernet interface. At this moment the house ligth are working fine with the PLC. I want to integrate the PLC to LinuxMCE.
   There are hexadecimal codes capable of create a connection between PLC and a PC. Now I´m trying to create that connection.
   I´m having trouble establishing that connection.
   Could anyone help me? Should the PLC be a server or client (I think a Server)? How do I open a connection and send/receive information?

Thanks in advance,


Pages: [1]