News:

Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - icantdothatdave

#1
Does anyone have UI2 working with an ATI card? If so, what did you have to do to get it working? I have a Radeon 9800 XT and can only run LinuxMCE in UI1.
#2
Installation issues / Re: Gray Screen and Nothing
March 26, 2007, 10:05:12 PM
The gray screen with lines is a garbled image of the first pluto screen that should be appearing when LinuxMCE launches. I had this problem until I installed the fglrx drivers for my ATI card. Previously, I was just using the ati driver that installs with Edgy. After installing fglrx I was able to get LinuxMCE running, but UI2 maxes out my CPU 100% of the time. I have to use UI1. It's not as pretty, but it runs just fine. I was able to watch movies and mess around with setup.
#3
Installation issues / Re: HAL error
March 26, 2007, 10:01:25 PM
I get the same error, but it hasn't affected my system in any noticeable way. Linux MCE works just fine in spite of this, and as far as I can tell, HAL is in fact working even though it gives me the error message.