OK answered 1 myself! For some reason didnt get on too well with the scenario wizard. The got it through scenario screens themselves.
- Welcome to LinuxMCE Forums.
News:
Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Users / Setup help
December 30, 2009, 11:15:31 PM
Hi
New to this! Just installed system 710. This is primarily to control heat and light in garden office.
Config is core/hybrid with USB Z Wave dongle and a huge total of one appliance switch at the moment (ZRP210) attached to a heater.!
I have a couple of questions if anyone could point me in the right direction:
a) The appliance switch I have automatically comes up as a light. Which is fine. But it would be nice to have it in the climate section. I cant seem to figure out how to get it to come up there. ie so on/off in the office climate section would be for the heater attached to this switch.
b) I havent had much luck getting an orbiter onto my Windows Mobile 6 phone, any ideas?
And going forward:
c) If i get a tempereature sensor, can the temp be displayed on the orbiter?
d) Anyone retrofitted a 2 gang Z Wave light switch in the UK? There are some new MK ones, Astral but they are very expensive!
Cheers
Rob
New to this! Just installed system 710. This is primarily to control heat and light in garden office.
Config is core/hybrid with USB Z Wave dongle and a huge total of one appliance switch at the moment (ZRP210) attached to a heater.!
I have a couple of questions if anyone could point me in the right direction:
a) The appliance switch I have automatically comes up as a light. Which is fine. But it would be nice to have it in the climate section. I cant seem to figure out how to get it to come up there. ie so on/off in the office climate section would be for the heater attached to this switch.
b) I havent had much luck getting an orbiter onto my Windows Mobile 6 phone, any ideas?
And going forward:
c) If i get a tempereature sensor, can the temp be displayed on the orbiter?
d) Anyone retrofitted a 2 gang Z Wave light switch in the UK? There are some new MK ones, Astral but they are very expensive!
Cheers
Rob
Pages1