Hi
New to this! Just installed system 710. This is primarily to control heat and light in garden office.
Config is core/hybrid with USB Z Wave dongle and a huge total of one appliance switch at the moment (ZRP210) attached to a heater.!
I have a couple of questions if anyone could point me in the right direction:
a) The appliance switch I have automatically comes up as a light. Which is fine. But it would be nice to have it in the climate section. I cant seem to figure out how to get it to come up there. ie so on/off in the office climate section would be for the heater attached to this switch.
b) I havent had much luck getting an orbiter onto my Windows Mobile 6 phone, any ideas?
And going forward:
c) If i get a tempereature sensor, can the temp be displayed on the orbiter?
d) Anyone retrofitted a 2 gang Z Wave light switch in the UK? There are some new MK ones, Astral but they are very expensive!
Cheers
Rob
