As I do not have Monostable/Momentary light switches, I believe I need to change a switch parameter for the Fibaro z-wave dimmer module (Parameter 14 to value 1), to support my bi-stable existing UK light switches.
Is it possible to make this parameter change using LinuxMCE/Dianemo?
yes, it is.
http://wiki.linuxmce.org/index.php/Tweak_advanced_ZWave_settings
Thanks Hari
Following the wiki I get to the panel to send/change the parameters, and my admin screen looks a little different:
(http://mardibloke.co.uk/adw/setconfigparam.png)
The z-wave device I wish to update is on Port 6 ( which I guess is 'node id' and so the first field )
The Parameter I wish to change is 14
The value I wish parameter 14 to have is 1
this is the screen for associations.. you need to reload the web page and sleet the screen for config settings..
Thanks Hari, I'm struggling to find where you are directing me.
I choose :
Wizard / Devices / Interfaces
Click on Advanced for the Zwave interface
Shows me my ZWave device ( Template #1754 )
Click on Send command to device
I now have a drop down list with the options:
Add Node
Assign Return Route
Download Configuration
Remove Node
Report Child Devices
Reset
Send Command to Child
Set Association
Set Config Parameter
Set Polling State
SetWakeUp
Status Report
you want "Set Config Parameter"
and set config param is the screen shot above, that appears incorrect.
Looks like a Dianemo oddity, if Linuxmce is the same as the wiki screenshots.
Thanks for your suggestion to exclude device from network, and include it again. It didn't fix this issue, but noticed when excluded that the wall switch works fine - see my new thread.