LinuxMCE Forums

General => Installation issues => Topic started by: mardibloke on January 20, 2013, 07:43:04 pm

Title: Changing Parameters on Fibaro z-wave dimmer - Dianemo
Post by: mardibloke on January 20, 2013, 07:43:04 pm
As I do not have Monostable/Momentary light switches, I believe I need to change a switch parameter for the Fibaro z-wave dimmer module (Parameter 14 to value 1), to support my bi-stable existing UK light switches.

Is it possible to make this parameter change using LinuxMCE/Dianemo?


Title: Re: Changing Parameters on Fibaro z-wave dimmer
Post by: hari on January 20, 2013, 09:48:39 pm
yes, it is.
Title: Re: Changing Parameters on Fibaro z-wave dimmer
Post by: hari on January 20, 2013, 09:50:10 pm
http://wiki.linuxmce.org/index.php/Tweak_advanced_ZWave_settings
Title: Re: Changing Parameters on Fibaro z-wave dimmer
Post by: mardibloke on January 20, 2013, 10:07:39 pm
Thanks Hari

Title: Re: Changing Parameters on Fibaro z-wave dimmer
Post by: mardibloke on January 21, 2013, 10:08:25 am

Following the wiki I get to the panel to send/change the parameters, and my admin screen looks a little different:

(http://mardibloke.co.uk/adw/setconfigparam.png)

The z-wave device I wish to update is on Port 6  ( which I guess is 'node id' and so the first field )
The Parameter I wish to change is 14
The value I wish parameter 14 to have is 1


Title: Re: Changing Parameters on Fibaro z-wave dimmer
Post by: hari on January 29, 2013, 10:06:18 am
this is the screen for associations.. you need to reload the web page and sleet the screen for config settings..
Title: Re: Changing Parameters on Fibaro z-wave dimmer
Post by: mardibloke on January 29, 2013, 09:57:57 pm
Thanks Hari,  I'm struggling to find where you are directing me.

I choose :

Wizard / Devices / Interfaces

Click on Advanced for the Zwave interface

Shows me my ZWave device ( Template #1754 )

Click on Send command to device

I now have a drop down list with the options:

Add Node
Assign Return Route
Download Configuration
Remove Node
Report Child Devices
Reset
Send Command to Child
Set Association
Set Config Parameter
Set Polling State
SetWakeUp
Status Report


Title: Re: Changing Parameters on Fibaro z-wave dimmer
Post by: hari on January 30, 2013, 10:55:55 am
you want "Set Config Parameter"
Title: Re: Changing Parameters on Fibaro z-wave dimmer - Dianemo
Post by: mardibloke on January 30, 2013, 11:13:21 pm
and set config param is the screen shot above,  that appears incorrect.

Looks like a Dianemo oddity,  if Linuxmce is the same as the wiki screenshots.

Thanks for your suggestion to exclude device from network, and include it again.  It didn't fix this issue, but noticed when excluded that the wall switch works fine - see my new thread.