Hi,
i did create a new template for each of the devices (amp, tuner and cassete deck), did not pick any of the pronto templates, and did cut and paste all the ir codes, including the DSP modes (picketd from remote central), tested all of them (all worked) and after that, under AV Devices, added each of them, all controlled by USB UIRT Embedded Transmit, under connecton wizard created the pipes or every device, and after that, under AV Properties, tested all the IR controls and all did work.
When i go to the OSD menu and select TV, amp switches to correct input, but selects the wrong DSP mode, which does not produces sound, since the TV signal is stereo only even if being sent via SPDIF/Optical to the amp.
The question is about how to define the " key strokes" to be sent to the amp when TV is selectd, in order to disable DSP mode and having it stero.
Another question is regarding the IR code set in the template. My IR control (the original one) has 12 buttons (1 to 12) and each of them has 2 or 3 DSP modes, i.e, hitting 1 i get concert hall 1, hitting 1 twice, i get concert hall 2, but 1 must be pressed twice in a time delay or i will select again concert hall 1.
I would lke to know how can i define DSP mode 2 sending the hex code twice with a time interval between both codes (they are equal = button 1).
Thx in advance for you r help.
