Here it is...
Bus 003 Device 002: ID 2304:0225 Pinnacle Systems, Inc. [hex]
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 2.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 8
idVendor 0x2304 Pinnacle Systems, Inc. [hex]
idProduct 0x0225
bcdDevice 0.01
iManufacturer 1 Pinnacle Systems
iProduct 2 PCTV Remote USB
iSerial 5 7FFFFFFFFFFFFFFF
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 32
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 3 StandardConfiguration
bmAttributes 0xa0
(Bus Powered)
Remote Wakeup
MaxPower 100mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 2
bInterfaceClass 255 Vendor Specific Class
bInterfaceSubClass 0
bInterfaceProtocol 0
iInterface 4 StandardInterface
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0040 1x 64 bytes
bInterval 10
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x02 EP 2 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type None
Usage Type Data
wMaxPacketSize 0x0040 1x 64 bytes
bInterval 10
Device Status: 0x0000
(Bus Powered)
Hi again,
Now armed with the info above we can add the Vendor/Product ID to the mce_usb device template on your Core and after a reload router it should be detected properly;
Got to Web Admin -> Advanced -> Configuration -> Device Templates
In the ID field to the left of the 'Go' button type the ID of the mce_usb2 template - 1862 and then click the 'Go' button. A new window will open to display the parameters of the Device Template. Scroll down to the section called 'Plug-n-Play' and find the last empty entry in that section - this where you will add the details of your MCE Transceiver. Add the following values to the fields for your MCE Transceiver;
From = 0
T0 = 0
PnP Protocol = Xap
Parms = 175|pci
Now add the Vendor/Prod ID data from the output of your lsusb command for the Pinnacle to the 'Vendor Model ID' field;
Vendor Model ID = 23040225 (**Notice you do not need the colon**)
Then in the 'Comment' field enter some text to identify the Transceiver;
Comment = MCE I/R receiver (Pinnacle)
Now lastly click save at the bottom of the page and then do a reload router. Now plug your Pinnacle transceiver into a usb port and it should get detected (you will see the detection and setup scripts run and be announced in the top left hand corner of the Orbiters screen... when everything has been setup you will see a message on screen confirming this and asking if you want to reload the router. Please click the reload button... and your Pinnacle transceiver should be working fine.
You can also see a short Wiki page I have added on doing the above here
http://wiki.linuxmce.org/index.php/Adding_a_New_MCE_Compatible_TransceiverAll the best
Andrew
