Author Topic: UPnP  (Read 1965 times)

coley

  • Guru
  • ****
  • Posts: 492
    • View Profile
UPnP
« on: April 30, 2008, 11:32:41 am »
Spotted a new entry under configuration for UPNP but when I select it, the main frame on the web-admin page reports it cannot connect on the port it tries.
I see fuppes trying to start on boot but it complains about eth0 not being a complete address - how do I switch it to be my internal NIC?

thanks
Coley.

looks like it should be in my fuppes.cfg file - will check later.

turns out it was on the correct port - the ip address of the internal nic has to be specified - as opposed to localhost, then the config web page appears.

I tried leaving the ip address range blank in fuppes.cfg to allow any ip connect but web admin still only appears when the LMCE admin interface is launched from 192.168.80.1.

Also noticed here http://forum.linuxmce.org/index.php?topic=5042.msg29860#msg29860
« Last Edit: May 02, 2008, 11:35:44 am by coley »