Does somebody have working GC100 in Beta4?

[nite_man]

Hi,

I setup GC100 under Beta3 successfully. Using a web page I found appropriate Pronto code group for my Toshiba TV (actually it was the fist one - Pronto Codeset - 0062). But in Beta4 GC100 doesn't work. I see that green indicator on the module is blinking as well as red one on the emitter when the command is sent from LinuxMCE admin page. But TV doesn't not respond to it. I don't see any error in the GC100 or DCERouter logs.

So, I'd like to know does somebody have a working GC100 under Beta4?

Thanks in advance.

[Zaerc]

I'm only using the GC100's serial port at the moment, that works.  Unfortunately my old TV broke a while back so I never got around to sorting the IR and can't say much about that.

[nite_man]

I'm only using the GC100's serial port at the moment, that works.  Unfortunately my old TV broke a while back so I never got around to sorting the IR and can't say much about that.

In any case, Zaerc, thanks for your answer. Will see if somebody else uses GC100 to emit IR commands.