I have been trying to get a GC100 installed on linuxmce.
I think it is well established that the script is broken. I used the "Add GC100" button which failed.
I used the MAC address hack which resulted in the GC100 being added but the IR ports did not appear to be added and when adding A/V device the IR ports box is not offered.
I also saw residue from the install where the secondary address was still active on the ifconfig and the Device_DeviceData table had data in it that looked like what the gc100 config script was using. I hard coded my eth0 to 192.168.1.250 on initial install from CD.
Is there a way to remove all remnants of the gc100 install or a way to manually add anything missing or not configured during the incomplete installation of the gc100. I need the IR and then serial to plug in my Sharp DTV
Charles
