Author Topic: IP Phones Plug-N-Play  (Read 5857 times)

PeteK

  • Guru
  • ****
  • Posts: 408
    • View Profile
IP Phones Plug-N-Play
« on: June 08, 2007, 12:43:05 am »
Does anyone have a list of the IP phones that LinuxMCE will automatically recognize (by MAC address) and configure?  I know Cisco phones work.  Any others?

thanks,
-Pete

Juliet Smith

  • Regular Poster
  • **
  • Posts: 41
    • View Profile
Re: IP Phones Plug-N-Play
« Reply #1 on: June 08, 2007, 09:07:37 am »
Snom 200/320, BudgeTone

pixelator

  • Veteran
  • ***
  • Posts: 70
    • View Profile
Re: IP Phones Plug-N-Play
« Reply #2 on: June 10, 2007, 04:09:34 pm »
I just received 2 GrandStream Budget Tone 200 SIP phones to test.
As soon as I plugged them in and booted them up, Pluto detected them and asked If I wanted to use them..

I wish setting them up in Asterisk was as simple  :P

Joshua

  • Making baby steps
  • Posts: 2
    • View Profile
Re: IP Phones Plug-N-Play
« Reply #3 on: August 02, 2007, 07:03:51 pm »
The thread says Cisco phones just work. Does it have to be a certain protocol to work correctly? I spent a month getting three 7960s upgraded from the very first version of SCCP/Skinny (It was a hastle becuase the old firmware version didn't want to be upgraded.) to the latest SIP protocol. Do I need to flash them back to SCCP/Skinny to have LinuxMCE auto configure them? Or will SIP work just fine?

Zaerc

  • Alumni
  • LinuxMCE God
  • *
  • Posts: 2256
  • Department of Redundancy Department.
    • View Profile
Re: IP Phones Plug-N-Play
« Reply #4 on: August 02, 2007, 07:19:01 pm »
There is a wiki page on adding the CISCO 7970 phone here: http://wiki.linuxmce.com/index.php/Add_CISCO_7078_Orbiter that you might want to look at for some info.

"Change is inevitable. Progress is optional."
-- Anonymous


atreidae

  • Regular Poster
  • **
  • Posts: 35
    • View Profile
Re: IP Phones Plug-N-Play
« Reply #5 on: August 22, 2007, 02:33:12 pm »
it detected a polycom phone and threw it a bootp config, but i didnt investigate more than that.

nite_man

  • NEEDS to work for LinuxMCE
  • ***
  • Posts: 1019
  • Want to work with LinuxMCE
    • View Profile
    • Smart Home Blog
Re: IP Phones Plug-N-Play
« Reply #6 on: August 22, 2007, 03:04:55 pm »
Cisco 7970 works fine with Plutohome 2.0.0.44. It offers an Orbiter - not so useful but better than nothing and calls of course. I configured private VoIP gateway via Asterisk web interface during 10 minutes (you may see my brief how to here - http://smart-home-blog.com/writes/configure-sip-gate-for-asterisk). I just install proper codec for Cisco. And know it's possible to make a calls outside home.

Michael Stepanov,
My setup: http://wiki.linuxmce.org/index.php/User:Nite_man#New_setup
Russian LinuxMCE community: http://linuxmce.ru