RAID array in webadmin only showing 2 of 4 drives

[fibres]

Hi guys

I have had this issue for some time but not really paid it much attention.

I have a 4 drive RAID 5 array setup using mdadm.

This was setup and configured on a previous install and was picked up when I re-installed.

Now for some reason when I go into the webadmin, configuration, raid it shows the RAID status as OK but only shows 2 drives.

However when I ssh to the core and run mdadm -D /dev/md0 it shows there is 4 drives.

Any ideas?