LIRC Setup and configuration for iMON

[Marper]

I've looked at many posts on this topic and can't seem to get the steps down correctly to get this installed.  I'm attempting to configure my iMON remote that came with my silverstone case and VFD. 

Saw a post frrom nite_man that outlined what to do, but I'm lost on what is being indicated by copy configuration file.   Here is what I've done so far:

1.  Created ne manufaccturer (after that the wiki instructions indicated I need to add a new template for that manufacture) I THINK I GOT THIS ONE CORRECT

2. In the new template add the property - Configuration and put the LIRC configuration file for iMON PAD (NOW I'm lost!!!  I se a section on what I believe is the new template that says configuration - that's just a single block, very small).

Am I doing this right, although I have not gone any further I wanted to ensure that I did not miss anything.   I looked at the screen shots from nite_mans post and the templat he has does not look the same as what I have.

When I've selected the manufacturer and category, I've clicked the button to add template and another screen is presented with 3 selections.  Is that where I addd the template ? 

Any help would be greatful.

[tkmedia]

yup in that little box paste your configuration file.




Tim

[Marper]

Thanks tkmedia - can I just use a file that I've found on the net under LIRC ?

[tkmedia]

Should be able to yes.




Tim

[Marper]

Ok, I guess I'll need to start over.  I followed wiki step by step and still am not able to get this going.  Can I go into the WebAdmin and delete all of the templates I've created "only" ?  The reason I want to start over, is when I finished everything, I went into the MD page and selected "add remote" I continue to get the select templates page.  I'm lost on this one, I'll continue searching the web to see if I can find a more end user version of the setup for this device.  Thanks