MD is stuck in a Reboot Loop during network install

[fearingsept]

I finally started integrating LMCE into my home. Up until now I was just using a Hybrid/Core. When I went to add my MD It starts the network install but then it restarts. It keeps looping like this over and over to no end. Does anyone have any ideas?

[Zaerc]

Does it have 2 NICs by any chance?

[fearingsept]

Yes It does.
I can use my desired MD when I boot into windows. It seems my internet connection is working just fine but when I switch over to network boot it keeps rebooting shortly after announcing its self.

[Zaerc]

The diskless boot has a problem when there is more then one NIC present, try disabeling the other one in the bios, or remove it if it's a PCI-card.

[fearingsept]

Wait.. I'm sorry I thought you were referring to my core.
No the MD does not have 2 NIC's Just one. It is the on board 10/100. The computer is an older Dell. I forgot the actual specs other then it being a P4 and was built sometime around 2004. I think the processor is 2.4ghz. It is also temporarily sporting the on board intel video.
Wasn't sure if this would support UI2 or not but I wanted to at least see if I could get it to boot before I replace the Video