Insteon Smartlinc 2412N

[foogee]

I am trying to get the Insteon Smartlink 2412N working form the directions provided in.

http://wiki.linuxmce.org/index.php/Insteon_-_Setting_Up_PLM_Template


The template is Plug and Play, configuration should have been taken care of for you.
Goto LinuxMCE Admin Website-->Wizard-->Devices-->Interfaces
Add device-->Template Id 1932 Insteon PLM
For 2412N
Add device -->Template Id 2197 Smartlinc


in addition to that i have set the ip address and mac address inside the template.

the device does not register. there is no log file for the device.   if i try to send command or reset the device i get the following in:


==> DCERouter.log <==
08 08/14/12 17:23:09.504  Received Message from 0 (unknown / ) to 83 (Smartlinc / ), type 1 id 373 Command:Private Method Listing, retry none, parameters: <0x5a19ab70>
05 08/14/12 17:23:09.504  The target device 83 (routed to 83) has not registered. <0xb7758b70>
05 08/14/12 17:23:09.554  Socket::ReceiveData 0xa6a61f28 failed, bytes left 0 start: 15760000 1: 0 1b: 0 2: 0 2b: 0 m_Socket: 164 Incoming_Conn Socket 164 127.0.0.1 <0x5a19ab70>
05 08/14/12 17:23:09.554  Socket::ReceiveString2 ReceiveData failed m_Socket: -1 Incoming_Conn Socket 164 127.0.0.1 <0x5a19ab70>
05 08/14/12 17:23:09.554  TCPIP: Closing connection to -1003 (Router Dev #0) 0xa6a61f28 m_Socket: -1 <0x5a19ab70>
05 08/14/12 17:23:09.554  Router::RemoveAndDeleteSocket 0xa6a61f28 -1003 <0x5a19ab70>

can someone please point me in the right direction?

[foogee]

never mind! the directions are perfect. i just needed to reboot!!