Zwave sensor installation problem in snapshot #23165

[ccoudsi]

I just found out, when installing a zwave motion sensor "ZIR000" in snapshot #23165, using Sarah, two "Generic Sensors" get created one under (Zwave=>Zwave embedded security interf) which is OK, and a second one under (Core) which is not OK, and causing after reload to get "Orbiter cannot register with the router. Please try again later", I attached a snapshot that depict what I just mentioned.

Solution:
Delete the sensor under the Core and regenerate the oribiter and reload the router, everything is ok at this point.

P.S> I installed this zWave setup many times in the past no issues found, this is the first time I see this.

[tschak909]

Uh oh, bit by the setup wizard bug.


Can you please file a ticket for this, (with the tag of Duplicate Device tree gets created when motion sensors are set up in Setup Wizard)

This one has been a bit of an oddity left over since just past 0710, but nobody seems to have made a ticket for it.

We'll get this fixed. In the mean time, you'll need to delete the extra DT #1 (core) devices.

-Thom

[ccoudsi]

Sure Thom I'll do it in the morning.
Did you see the other UI issue too??

[ccoudsi]

Ticket was submitted http://svn.linuxmce.org/trac.cgi/ticket/782