Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - ardirtbiker

Pages: 1 ... 19 20 [21]
Installation issues / Re: Gyration Remote keys all wacky
« on: February 27, 2011, 02:43:35 pm »
Yahoo!!!    That fixed my gyration buttons issues too!!!


Just my 2 cents...    I have had no problems with the HDPVR (other than it doesnt autodetect so I had to add it to the Media Director on the admin page).

Ive moved it around a couple times because at one point MythTV stopped working... shortly after I added a gyration (DELL) remote.   I could get MythTV to work if I removed the USB receiver from my MD.   I intend to investigate further but the holidays make time very limited.


Thanks Thom!!!!

I'm workin on it...  :P 

    Yes... when i had my HDPVR on my core, I was able to watch fairly good quality tv on my MD thru the network.   Every once in a while, I would get a 'hickup' in the video and/or audio.  It was similar to watching a movie on my MD where the file was on my core. 
    Im running on a gigabyte lan, my core was an athlon64 with a gig of memory, and my MD is a dual core athlon64 with a gig of memory as well.   That may explain why i was having some luck.    But it actually works much better when the HDPVR is on the MD.

Installation issues / Re: 0810 64 bit support
« on: May 12, 2010, 04:17:06 am »
thats a rainy day thing!  8)

I had done this on my MD before, and also went into the core/hybrid and removed all reference to the HDPVR in Mythtv and in Web Admin.
Had no luck getting the setup to work.

I had another server ready to go, so I installed a new core/hybrid and joined my MD to the core.  Setup of Mythtv was successful... and it works perfectly.

I must have something misconfigured on my prior core...


Hello all,
    Ive been experimenting with LMCE for about a year.. slowly collecting hardware.
I have been working with the HDPVR on my core/hybrid, and can get it to work fine capturing Component video from my H20 Sat box.
My MD can watch the satellite broadcasts as well thru the network, however only one MD can access the HDPVR at a time.  I figure that the H20 Sat box and the HDPVR should be on the MD anyway (each MD would have same setup).   However, configuring the MD in Mythtv setup exactly the same as it was on the core, and relocating the HDPVR to the MD usb port, watching tv fails with a message "Mythtv is using all inputs, but there are no active recordings?"

Restart of entire system results in the same outcome.   Removing the HDPVR references in the core/hybrid Mythtv setup and restarting still results in same outcome.   Relocating the HDPVR and H20 back on the core/hybrid, and reconfiguring as original, and satellite transmissions can be watched on the core/hybrid, or the MD.. but not both simultaneously.

Any recommendations on what I might look at to resolve this issue?   I woud assume that each MD should be able to support a capture device and have a satellite box local to it to watch different programming that another MD.


Pages: 1 ... 19 20 [21]