Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wesattexas

Pages: [1]
1
Installation issues / Re: Two Nics
« on: July 27, 2008, 03:19:47 am »
Thanks for the quick answers.
So I guess your suggestion is to get rid of one of my
capture cards and install a second Ethernet Card.

What I keep finding in the forms is:
"... did you follow our instructions for setting up the network?
two NICs, one connected to your modem,
the other connected to your internal switch..."


In my case - a Fujitsu DSL modem with Ethernet out
and a linksys switch/dhcp/NAT router/firewall with
a WAN port and five additional ports.
Of course I will disable the dhcp, and avoid the [WAN]
port to disable any additional NAT and firewall inside my
"internal" network.  Of course there will be nothing to plug
into the other ports on the linksys as the MCE hybrid is the
only computer.

What worry's me is putting the linuxmce directly on the Internet.
I think it would be very dangerous for most people to put
the full attack surface of a high value target like a barefoot
linux high end media pc on the dirty side of a firewall.
Even if Kubuntu has a built-in software firewall. 
Don't they have yearly contest to see NOT IF, but HOW LONG
it takes to break-in and take over highly protected computers.
At least behind a NAT firewall the hackers have to wait
for the target to establish a connection with them and mostly
the hackers go for easy prey like no dedicated firewall.

Also If it's important to have no firewall between the Internet and
the Hybrid then will it be possible to install linuxmce at my dad's?
I set up a linux pc for him to do email and look up stuff on google.
His ATT- SBC modem is integral Modem/usb/Ethernet/wireless/four port switch.
and one PC.
No way to get in between modem and router.
This is his only PC and I would like to add a capture card and mce.

2
Installation issues / Two Nics
« on: July 26, 2008, 09:44:39 pm »
Is there a good discussion on the board about the pros and cons of having/not having two nics.

Here is my current hardware:
ASUS M2NPV-VM MainBoard BIOS#0603 AMD 64x2 - 4400
Kingston DDR2 4200 DUAL KINGS 1Gb
2ea SATA 300 300GB
1ea SATA DL DVD Burner
WinTV 32552  (PVR-150 MCE ?) capture card
pcHDTV HD-5500  capture card

This Mother board has only two PCI slots and already has a Gig Ethernet built in.
It's plugged into a Gig switch.
At this point I don't see multiple additional TV's as part of my system,
though home security, Voip, and X-10 are high on the list.
I thought a single hybrid server would fit my needs best.

I have read about external nic's and internal nic's, and modems as nic's...?
It all seems very confusing.
Would the second nic require me to wire a duplicate cat-5 network.
What traffic would flow on each network.

I'm sure all this has been discussed at length, but I can’t find any of the threads.

One additional comment:
I downloaded the software at work.  Finished late one night.
Couldn't wait to get home and try the install.
We work in a Network support shop and we have lots of spare machines around.
So I stuck the i386 DVD version of the software in a new DELL OPTIPLEX.
And went through a quick install just to familiarize my self.
Then I shut the system down and went home.
Imagine my chagrin when I came in the next evening shift and
found out the box had reset instead of going completely down.
... It only took our guys a short while the next morning to find out
why no one could get on the network, because that’s what we do.
My linuxmce was handing out IP addresses much quicker than the
Remote DHCP server could.
It seems that it would be a good thing to mention that by default
linuxmce will install DHCP and provide address to its own private non-routed
subnet and it might be a good question to ask during the install:
  Do you want DHCP service?
Well only a little damage done and most of that to my ego.

Looks like this is going to be a fun project
and I can hardly wait to get it all up and running.

Regards,  Wes

Pages: [1]