Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - nickleboyblue

Pages: [1]
1
If we were to set security-specific USB cameras to only take snapshots once every five seconds, regardless of which orbiter was accessing them, we could then create a software alternator to switch between cameras on the same bus so that only one camera would be running at a time.  This would allow for multiple USB cameras to be installed on LMCE on the same bus.  The hope is that this would allow people to set up a fully functional, state-of-the-art security system using nothing more than one computer, a network of usb hubs, and USB webcams set up as security cameras.

Is this a possibility?

2
Users / Multiple USB security camera sensors...?
« on: February 20, 2010, 07:53:27 pm »
I need help setting up multiple USB camera sensors.  I read somewhere that it is bad to connect multiple USB cameras to the same USB bus, but that it might be possible to modify the driver to provide enough bandwidth to run multiple USB cameras on the same USB bus.  How is this done?  I need to connect two or three of them to the same USB hub if possible, which would clearly be a USB bandwidth overload unless the driver is modified as suggested above.

Pages: [1]