Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - joesixpack

Pages: [1]
1
Users / nokia e62 phone
« on: August 12, 2007, 02:20:20 am »
Is this working now with the latest release? I lost my bluetooth adaptor in a bar fight in malaysia and I don't want to buy a new one if I don't have to.

Thanks

2
Users / low disk space
« on: June 21, 2007, 03:15:16 am »
ok....i'm getting a low disk space message now. just started when i added a md (diskless boot). the core has plenty o' space...i checked. what do i need to do? i'm freakin out here! ....not really.

report from hd:

Filesystem    Type    Size  Used Avail Use% Mounted on
/dev/sda1     ext3    227G  130G   86G  61% /
varrun       tmpfs    506M  292K  506M   1% /var/run
varlock      tmpfs    506M     0  506M   0% /var/lock
procbususb   usbfs    506M   96K  506M   1% /proc/bus/usb
udev         tmpfs    506M   96K  506M   1% /dev
devshm       tmpfs    506M     0  506M   0% /dev/shm
lrm          tmpfs    506M   33M  473M   7% /lib/modules/2.6.20-15-generic/volat

thanks

3
Installation issues / Regin Orbitor hanging at screen 66
« on: June 19, 2007, 06:45:03 pm »
OK, I did another clean install and everything was going great until I noticed that the myth database wasn't being filled, so I stopped media center from the control panel and ran mythfilldatabase. Everything went ok until I restarted the core. When it went to regenerate the screens for the on-screen orbiter it hung at #66. I restarted again and it did the same thing. Then I deleted the on-screen orbitor from the admin page and created a new one.....same issue. At this point I started over with a clean install....again. Any ideas about fixing this if it happens again? I'm sure there's an easier way.

Thanks

4
Users / How do I change network card id's?
« on: June 12, 2007, 09:26:42 pm »
OK, I hope someone can make sense of my question. I installed LMCE and set it up to use eth0 & eth1. eth0 did not want to be a team player so I installed another card which is now eth2. I used udev to rename eth2 to eth0 but that aint working. The admin page doesn't allow you to add network cards to the settings that I can tell. 

Is there any way to re-run the network portion of the setup only, to configure the changes or do I have to re-install???

Peace out

Pages: [1]