hari,
Thanks so much. That helps.
Thanks so much. That helps.
- Welcome to LinuxMCE Forums.
News:
Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Users / ZCS101 RS232 Interface Dead?
April 20, 2013, 04:12:56 AM
I received a new ZCS101 w/RS-232 interface. I have done nothing else with it other than power it on and connect serially to a PC. I cannot get any output despite repeated attempts at differing baud rates and serial port settings. It just looks dead. My question is whether I have a bad expectation -- should I be able to enter ASCII commands? It is the case that there is typically no firmware on a fresh unit?
Pages1