Messages

Yes,  LinuxMCE  automatically detected and installed the CM15A unit.  I see it listed under Device Status in the Admin site.  I've added a simple on/off light for testing and that shows up as well.  It is in the log for the CM15A unit that I see pages of the error message in my original post.

Yesterday I downloaded the newest snapshot and loaded it today, but I'm having the same trouble.

Thanks

Hi all,

I've installed the most current snapshot of 8.10 and trying to set up and use X10 with a CM15A module.  For now, I've loaded it in a virtual image under VirtualBox.  the goal is to learn LinuxMCE and then make a permanent installation for my home.

The problem I'm seeing is in the log of the CM15A unit, there are many pages of:  received <58 41 e7 ea 2f 81 61 00> unknown data <0xb61d8b90>
The unit does not turn on and off a test lamp that's setup.  The unit and lamp will respond to commands from a standard X10 hand control.  It will also work from AHP.

Second, more general question:  After signing out of the Administration page, the control panel is usually gone and a black window is left.  Is there a way to get back to the control, so far I've had to reboot the whole image.

Thanks in advance for any help!

Jim