Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - neilbrown66

Pages: [1]
1
Installation issues / Re: hauupage nova td 500 issues
« on: April 21, 2010, 12:32:52 pm »
Hi Guys

Thanks for your help, sorry for the slow reply. it seems as thought i have already ran the command to load the vl42 modules. However i have ran them again and attached the results, hope you don't mind.

It seems as though some packages have not installed as they are missing from the servers or have been moved (see attached)

Any body got any ideas?

Neil


2
Installation issues / hauupage nova td 500 issues
« on: April 15, 2010, 07:28:29 pm »
Hi
I am having issues with the Nova td 500 card in linuxmce. The card works fine in XP and i have had limited success with getting it to work in Myth TV 09-10

I have followed the instruction on the following link

http://www.mythtv.org/wiki/Hauppauge_WinTV_Nova-T_500_PCI which seem to go through ok but upon restart when i try and the TV card into director it is not in the list. I have chosen the option of nova t 500 but i get no signal

Reading further down the above page i found the command  below, and with the following results. I have tried copying the firmware file to lib/firmware directory but still get the same error message

Can any one help please?

dcerouter_1009344:/# dmesg | egrep "dvb|v4l|dvb-usb|ic2|mt2060|error"

[    0.264550] ..TIMER: vector=0x31 apic1=0 pin1=2 apic2=-1 pin2=-1
[    5.692514] usb 4-3: device not accepting address 2, error -62
[   12.045717] dvb-usb: found a 'Hauppauge Nova-TD-500 (84xxx)' in cold state, will try to load a firmware
[   12.045722] firmware: requesting dvb-usb-dib0700-1.20.fw
[   12.537172] dvb-usb: did not find the firmware file. (dvb-usb-dib0700-1.20.fw) Please see linux/Documentation/dvb/ for more details on firmware-problems. (-2)
[   12.537197] usbcore: registered new interface driver dvb_usb_dib0700
dcerouter_1009344:/# dmesg | egrep "dvb|v4l|dvb-usb|ic2|mt2060|error"
[    0.264550] ..TIMER: vector=0x31 apic1=0 pin1=2 apic2=-1 pin2=-1
[    5.692514] usb 4-3: device not accepting address 2, error -62
[   12.045717] dvb-usb: found a 'Hauppauge Nova-TD-500 (84xxx)' in cold state, will try to load a firmware
[   12.045722] firmware: requesting dvb-usb-dib0700-1.20.fw
[   12.537172] dvb-usb: did not find the firmware file. (dvb-usb-dib0700-1.20.fw) Please see linux/Documentation/dvb/ for more details on firmware-problems. (-2)
[   12.537197] usbcore: registered new interface driver dvb_usb_dib0700
dcerouter_1009344:/# mv dvb-usb-dib0700-1.20.fw /root



Pages: [1]