Thanks everyone!!! I was able to get this working it, it turn out I didnt understand that it didnt look for the wireless and I had to tell it where to go. after I put in the network name "bingo!!"
Thanks again!
Thanks again!
- Welcome to LinuxMCE Forums.
News:
Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Users / Webdt not connecting
January 26, 2010, 07:36:47 PM
I know this has a lot of posts and I think i tried all the fixes, or tried to.
so here is my problem I loaded the webpad-gamma1 on the 366 and got the TabletCFG screen from there I choose "none" then ok it then goes back to splash screen and stays.
1. I seen in a post to make sure that mac filtering is off, it didnt say where the setting is so I looked in LMCE web admin and found nothing, tried to find my WAP... I turned off DCHP on the netgear wireless router to let LMCE handle the DCHP server and now I cant find the Netgear....
2. I also seen someone post something about telling what WAP to connect to but I dont under stand where to input this on the webpad, when I run TabletCFG there is a place to put in ESSID and Key and because I dont have any security i left these blank. I did look at the iwconfig, ifconfig. they show no key
and most of the rest i didnt understand.
3. do I need to prep the core? what I have seen it if you use 2 nic's and default setting when installing the core it should find it without problems. My network is setup just like the links show.
At this point any help would be wonderful as I feel like such a noobie!!!
so here is my problem I loaded the webpad-gamma1 on the 366 and got the TabletCFG screen from there I choose "none" then ok it then goes back to splash screen and stays.
1. I seen in a post to make sure that mac filtering is off, it didnt say where the setting is so I looked in LMCE web admin and found nothing, tried to find my WAP... I turned off DCHP on the netgear wireless router to let LMCE handle the DCHP server and now I cant find the Netgear....
2. I also seen someone post something about telling what WAP to connect to but I dont under stand where to input this on the webpad, when I run TabletCFG there is a place to put in ESSID and Key and because I dont have any security i left these blank. I did look at the iwconfig, ifconfig. they show no key
and most of the rest i didnt understand.
3. do I need to prep the core? what I have seen it if you use 2 nic's and default setting when installing the core it should find it without problems. My network is setup just like the links show.
At this point any help would be wonderful as I feel like such a noobie!!!
Pages1