Messages

Well, the IOLinc "came and went"! It does appear in the logs of the PLM modem interface, but I cannot get it to "stick" in the configuration files. Its linked to a KeypadLinc switch, and I can control it from my office (where the keypad is located). I also can see the status in the keypad (lit for closed, unlit for open), but its now disappeared from MCE configurations. Ive re-loaded (ad rebooted) the MCE machine a couple times, and gone through the "process initialize" procedure on the PLM a couple times as well.

Hmmm... confusing. Any ideas?

Im going to try hooking up the second IOLinc and see if anything changes.

Thom - hey, thanks for the reply. While Im NOT a programmer, Im no stranger either to Linux and navigating from a CLI. If you can (or anyone) steer me in the right direction as to creating the appropriate templates and/or code Im all about  adding to the project... wherever I can.

Appreciate the insights though.

On a side note, I rebooted the VM this afternoon and magically one of the IOLics came to lifew in the lighting configuration (of all places). Id like this to be in the security area as Im using it for garage door control - it reports open/closed status adn also allows me to trigger the "button" as an insteon link... but that somehow showed up. Anyway, Ill keep plugging through, but I do like what Ive see so far - great project!

Thanks

Matt

Hello - my first post to the forum, however Ive been a guest for a couple weeks now and reading lots. I have recently installed 8.10 as a VM under Virtualbox and have functionality for my lighting running. Im using a Smarthome 2412S as a interface to several dimmers and switches throughout my home. I also have a few keypadLinc dimmers, Lamplinc 245D3 dimmers, and currently two IOLincs (# 2450).

At present (correct me if Im wrong) it doest appear that there is wide support for Insteon devices other than switches and dimmers. I havent found a setup for IOLincs (Im using these as garage door sensors and to also tp initiate the openers), not the Lamplic's.

Is there a guideline to "fat finger" this into a template so the MCE system will utilize these devices (assuming that I can get the relevant codes from Smarthome for the devices), or has this already been done and Im just not seeing it.

Thanks in advance