Messages

1

Feature requests & roadmap / Re: Hardware equipment for my project

« on: September 23, 2009, 03:51:20 pm »

So ok thank you for your responce and i am sorry for the bad section.
I goes to User section for my answer.
And i have find the IR receiver/transmetter after a longtime but i don't see the equipment for communicate with X10, KNX or other protocols.

Ok I go to good section and thanks a lot.

2

Feature requests & roadmap / Hardware equipment for my project

« on: September 23, 2009, 11:08:36 am »

Hello, first i would to say sorry for the writing mistake because i am french.

I would like to be my own little home automation with linuxMCE. Of software point of view it's ok, but for hardware should i choose...

So i explain my project to you:

I am a PC where i want install an hybrid LMCE after my adsl box. I would like control my ligth by X10,KNX or other i don't know for the moment.
I would like this hybrid can control my TV, my hifi system and my dsl decoder by IR. I would like one or more relay for future use and i would like VOIP by wifi.
I want to connect a usb webcam to the hybrid and a ip webcam on the network. And the most importante for me that i would like a remote by person and not by room as orbiter with a complete web 2.0 experience and another with only up/down/right/left/ok/cancel/[0-9] buttons.

So if you could guide me to find good equipment to put in my pc and what i need to do this, i'am very grateful to you.

For the orbiter i have tink to a nokia n810 or a chumby but it's little expansive. If you are an idea it is welcome.


Another question :

I work a little with french compagny of home automation. And i would to know if i want to integrate LinuxMCE in product for future client and can i costumize it with the socity identities whitout problem of law, license ect ...?

Thank you for your attention.