- Welcome to LinuxMCE Forums.
News:
Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Users / Re: Hi everyone!
March 27, 2009, 01:45:14 AM
Thank you for the warm welcomes. 
Yes, colinjones, I have read A LOT over the last few days. I hope I didn't come off as someone who was just "jumping in". As far as the network goes, I think I've got that covered too. I've got a Wirless N+ router for my LAN, two NICs for the core's mb. And, a 8 port gigabit switch for the LMCE-LAN. Plus, lots of CAT6.
totallymaxed, I do remember reading about an issue with the audio from that mb. But, I should be able to work around that. I already have the board. I don't intend on buying a replacement one unless I find insurmountable problems. I'll know soon enough.
Yes, colinjones, I have read A LOT over the last few days. I hope I didn't come off as someone who was just "jumping in". As far as the network goes, I think I've got that covered too. I've got a Wirless N+ router for my LAN, two NICs for the core's mb. And, a 8 port gigabit switch for the LMCE-LAN. Plus, lots of CAT6.
totallymaxed, I do remember reading about an issue with the audio from that mb. But, I should be able to work around that. I already have the board. I don't intend on buying a replacement one unless I find insurmountable problems. I'll know soon enough.
#3
Users / Hi everyone!
March 26, 2009, 10:04:30 PM
Hey folks. My name's Chris. I've been checking the board, wiki and docs out for the last few days. I have been a MythTV user on and off since 0.14. Unfortunately, I've had some odd HW failures with my Myth setups. 
I was getting ready to rebuild and decided I should give LMCE a shot first! I've dabbled in Linux for about 10years now. So, I'm relatively comfortable with what needs to happen to get my system up and running. Right now I'm battling thru a simple Kubuntu install on my ASUS m3n78-vm board. From what I've read, I should be able to get it running properly with a couple tweaks.
Anyhow, I just wanted to say hello. I'm looking forward to getting this project of mine off the ground.
I was getting ready to rebuild and decided I should give LMCE a shot first! I've dabbled in Linux for about 10years now. So, I'm relatively comfortable with what needs to happen to get my system up and running. Right now I'm battling thru a simple Kubuntu install on my ASUS m3n78-vm board. From what I've read, I should be able to get it running properly with a couple tweaks. Anyhow, I just wanted to say hello. I'm looking forward to getting this project of mine off the ground.
Pages1