Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - angrymeat

Pages: [1]
1
Users / WEbdt 366
« on: March 30, 2009, 04:37:41 am »
I know alot of people on here use the webdt 366 tablets and some use them for more than just the web orbiter  some guys started a site a few days ago over at webdt.org   that is becoming a community of 366 owners to share their experiences . I know this is not mce related but I have seen alot of non mce posts on here I thought maybe this would help those people find a place to put those.

2
Users / Re: Web DT366 DIY
« on: March 21, 2009, 07:47:06 pm »
i was just poiting thes eout because they are 44 pin  90 degree like the ones in the unit

3
Users / Re: Web DT366 DIY
« on: March 21, 2009, 06:12:22 pm »
http://cgi.ebay.com/Apacer-ADM3-4GB-44-pin-90-degree-Dual-Channel-5V_W0QQitemZ160319116675QQcmdZViewItemQQptZPCA_Cables_Adapters?_trksid=p3286.m20.l1116

4
Users / Re: Web DT366 DIY
« on: March 20, 2009, 09:17:09 pm »
I tried asking their support but my unit was sold to an oem   they work with so they wouldnt answer a single question or provide me with any kind of config manual

5
Users / Re: Web DT366 DIY
« on: March 20, 2009, 08:55:59 pm »
Is there perhaps a way to just make these units boot from a cf card in their cf addon slot ? I am trying to figure out how to make mine boot from that slot with little luck  .

Pages: [1]