Messages

1

Installation issues / Re: network storage

« on: May 20, 2008, 08:57:50 pm »

I had this same issue with attempting to get an external NAS to be seen by the core.  I followed the steps above to do this, but I always a problem when i would attempt to save something through the interface, it would tell me the disk was full everytime (even though is had almost 200GB of free space.  Through lots of trial and error I finally found a solution that worked for me, and might work for someone else too.  After your core is all setup on the network, go into your NAS device and change its static IP to 192.168.80.x (I used 200 so its outside the assignable IP range by the DHCP server).  Within 2 minutes of me doing this, the core found my NAS, configured it properly, and now works just fine to save anything to from he interface.

Just passing this along...

2

Feature requests & roadmap / Re: Feature Request - Netflix WatchNow Support

« on: May 20, 2008, 08:50:39 pm »

Well if the Netflix WatchNow is not possible directly through LinuxMCE, would it be possible to make it work using the new set-top box by Roku and have it connected to the core.

http://www.roku.com/netflixplayer/