Messages

Hello:

I'm a Home automation integrator!
My experience is over the EIB/KNX system, with this protocol you can control, Lights, Dimmers, Scenes, Shutters (motors), Havac or underfloor heating, etc.....

That EIB/KNX is a standard of Home Automation , the first in the world, and Linux have direct drivers!

I'm waiting a device, a RS232 -EIB/KNX gateway that arrives tomorrow, i hope, to test the direct connection to Linux MCE.

With this you can control all the house, with only one User Interface!

Regards

JS

Hello

I'm playing a DVD and exist a little delay between the Video that come first, and 1 or 2 seconds later I listed the sound.
I already try to do play it on the Core and at the Orbiter, rip de DVD to HDD, happens in all options! How can I fix it? Or what I'm doing wrong?

Please help me!     

Regards

JS

Hello

I'm playing a DVD and exist a little delay between the Video that come first, and 1 or 2 seconds later I listed the sound.
I already try to do play it on the Core and at the Orbiter, rip de DVD to HDD, happens in all options! How can I fix it? Or what I'm doing wrong?

Please help me!

Regards

JS

Hello Dan:

Some news about the driver??
You want some details about the protocol? Exist a lot of information about KNX/EIB protocol on the internet?
If you need some information about it, please send me a information!

I really need put this working!

Regards

JS

mickg,
I'm not too sure how well that driver is implemented.  From what I can gather, it hasn't been looked at since the pluto days.

If you can get me specs on the protocol, I can see what I can come up with.

Regards,

Dan

Right now I'm using a RS232 (serial) with V1.2, device of Siemens 5WG11481AB02.

I check if the group address and the import of the group address are correct, and they are.
I Already Add the lights, and when I force to On or OFF, nothing happens!

What I can do to test  step-by-step, and put these working!

Hello


Sorry about my English, I'm a Portuguese integrator! 

I'm trying to use the LinuxMCE with EIB/KNX light control. I have a EIB/KNX - USB gateway, but I have some difficult to config the interface, I already
1.   define the devices.
2.   define the Lights
3.   Import and Update the group Adresses
4.   When I try to do On/Off in any device os group adress, the EIB BUS do not receive any message!


I have doubts about config the interface, is necessary install some additional software?

Can someone give me a help, to put working, step by step, the information available on wiki is not very complete!


Thanks

JS