Messages

1

Users / Nvidia GeFORCE 7300 GT AGP

« on: January 20, 2008, 08:09:24 pm »

Ok i wanted to run UI2 with or without alpha blending...bought the above card and....it doesn't work.

It worked with UI1 and now trying UI2 with medium settings and whilst loading up the interface and the mouse is either frozen or moves very slowly and then i get booted into a shell and asked to logon!!!

SO i enter a userID and pass and nothing. I have no idea how to start the GUI from here.

Should i have configured the graphics card beforehand?

WHAT shall i do now i cannot even change the graphics back to UI1...then onl option i can think of is to re-install? 

Any comment (even 'you're and idiot') appreciated. #

[EIDT] can i load just Kubuntu from boot?

2

Users / Re: WiFi

« on: January 20, 2008, 01:10:46 pm »

What sort of throughput would i need to gain full functionallity.

I don't have a cat5 install in my home

How about 80211n with 74Mbit/s?

or wireless over you homes electrical ring? I think that can get to 200Mb/s

3

Users / WiFi

« on: January 20, 2008, 01:06:58 am »

Forgive me if this has been discussed before...i have looked through the Wiki but as a N00B not all of it rings bells.

I have a an ASDL modem that has WiFi

...and i have just installed a hybrid LMCE that is connected to it via an ethernet cable.

I have a WiFi card connected to the core. is there any way i can configure the core to connect to the internet via the ASDL modem through the ethernet port and use the WiFi card in the core for the internal network?

Or would i have to buy a switch or another WiFi router or both?


Thanks