News:

Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - pessimist

#1
ended up going back to beta1. 0704 version runs my cpu 100%, and altho top shows about 25%-35% load, kde system monitor and other monitors show 100% and the cpu is damn hot. back in beta1 its all normal again.
#2
@kir
yeah, tried that, and its a no go (no change).

@elspic
it's the setup wizard, as mentioned that was the wrong res. have not seen the AV wizard during this install.

previously used pluto for near 2 years, been running lmce since mid may. had no issues till now, and still using the same hardware.

i'll try a reinstall tomorrow morning and see if it turns out the same :(
#3
yup, i'm having the same issue.

altho i dont know how to 'fix' it, i hit the enter key and the login prompt appeared.
i logged in and did a 'sudo kdm start' and it started the setup wizard, altho it seemed to fix itself at 640x480. so i edited the '/etc/X11/xorg.conf'  file with a more appropriate resolution. it still hangs at the same point after a reboot, but doing the same as above (minus xorg.conf edit) starts it up to a usable point.

hope someone can shed some light.

thanks