Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Atzi

Pages: [1]
1
Users / Re: Zalman HD160XT revision 3 enclusure
« on: December 21, 2007, 07:04:45 pm »
@Hagen,
I don`t know if they used the same hardware in the 160, but I would believe so. I have connected the fans to my  beQuiet powersupply with a build in fancontrol. It works perfect, the fans are inaudibly.
Atzi

2
Users / Re: Zalman HD160XT revision 3 enclusure
« on: December 12, 2007, 12:21:06 pm »
HH (Hi Hagen)

I have a Zalman 160XT (Rev. 1 I think) and it is lots of work getting this to run with linux. The problem is not the LCD, this works out of the box. Touchscreen is a little bit of manual work, but can be done. But you have 5x Chassis Fan in there that need to be controlled by 2 USB temperature devices. So you need a driver for the usb-temp-devices and a script that manages the fan level. Leaving the fans at level 100 is not option as ... well, I think it is clear. I installed LinunxMCE last sunday so i am getting to this point, but my next case would not be Zalman 160XT for a linux setup.

Hope this helps...
Atzi

Pages: [1]