News:

Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - timgman

Pages1
#1
Installation issues / Re: orbiter software download problem
April 04, 2007, 03:01:17 AM
? a link would ROCK!! ;)
#2
Installation issues / Re: orbiter software download problem
April 03, 2007, 04:04:41 PM
Can anyone post this orbiterisntaller.msi?
my file is 0kb as well....
and yes I'm impatient. ;)
heheheheeh
thanks
#3
Users / Re: Linux MCE motion configuration with analog bttv 4 port cards...
April 03, 2007, 02:45:59 PM
FIRST OF ALL THANKS FOR THE GREAT PRODUCT..
I have them (both the 4-port bttv capture cards) working.. All I needed to do was follow the directions.
(and understand that the verbage may be slightly off being that the project is fresh....)
thanks.
timg
#4
Users / Re: Linux MCE motion configuration with analog bttv 4 port cards...
April 02, 2007, 07:32:19 PM
I gusee that main issue is that under security camers I see no option to

(excerpt from user guide below)


choose the motion wrapper as the "Controlled Via"
#5
Users / Linux MCE motion configuration with analog bttv 4 port cards...
April 02, 2007, 06:16:25 PM
I want to install 4 cameras connected to a 4 port bttv (wbay bt878-type) card..
motion via command captures images...
After following the manual I I see not way to map my security camera to /dev/vido0 port 1 or what ever..
has anyone ised this?
can I have a bit more direction on the setup?

thank you
.timg
Pages1