LinuxMCE Forums
General => Installation issues => Topic started by: twgray2007 on May 24, 2008, 04:50:37 pm
-
Just did a fresh install from the DVD. During the first boot, I go messages saying "device 1 has bad mac address" and no network access. Using the Web Administrator, I went to the network page. MCE had the interfaces reversed and when I press "swap interfaces" the computer reboots. Has anyone else experienced this?
-
Just did a fresh install from the DVD. During the first boot, I go messages saying "device 1 has bad mac address" and no network access. Using the Web Administrator, I went to the network page. MCE had the interfaces reversed and when I press "swap interfaces" the computer reboots. Has anyone else experienced this?
Yes this is normal... LinuxMCE will reboot when you change the network configuration.
Andrew
-
Thanks for the input, but I don't remember the former version of MCE rebooting in order to change interfaces. And, after the reboot, the interfaces remain the same.
-
Thanks for the input, but I don't remember the former version of MCE rebooting in order to change interfaces. And, after the reboot, the interfaces remain the same.
I think the reboot was brought in after Beta4... might be wrong about that though. As to the interfaces not getting swapped... I would suggest a check on Mantis to see if that is a known/reported issue and if not add a Mantis for it.
All the best#
Andrew