LinuxMCE Forums

General => Installation issues => Topic started by: Afkpuz on February 12, 2008, 06:21:49 am

Title: How to get fiire cheif to work outside of linuxmce
Post by: Afkpuz on February 12, 2008, 06:21:49 am
Hey, I bought a fiire chief and for complicated reasons (mostly hardware problems), I can't use Linuxmce until I buy a new monitor.  Until then, I'm going to use mythtv by itself as my media center.  So, does anyone know how to get all the buttons working in mythtv.  I know that the arrows work, but the channel change buttons aren't even registering in the set keys area.  Neither do the play, pause, etc buttons, nor volume.  Now, I don't think this should be too hard because becuase system>preferences>keyboard shortcuts recognizes the play buttons.  It doesn't however register the volume/channel.  So does anyone know how to configure the fiire chief?  Or is there a way to map the button presses to some key that mythtv recognizes?

P.S. once I get a monitor (the resolution was just way too low for Linuxmce (640x480)), I'll probably try linux mce again.