LinuxMCE Forums

General => Installation issues => Topic started by: teedge77 on September 09, 2007, 04:57:49 pm

Title: Problem using Asterisk
Post by: teedge77 on September 09, 2007, 04:57:49 pm
I have recently gotten the 7970 going. I can see it as an orbiter and it is being registered in Asterisk. When i go to use the AMP flash panel it wont load. i get this error

Quote
Error loading configuration file variables.txt?aldope=41869


looking it up i found two references to pretty much the same thing.

http://www.asternic.org/archives/msg01332.html (http://www.asternic.org/archives/msg01332.html)

http://www.asternic.org/archives/msg00262.html (http://www.asternic.org/archives/msg00262.html)


i havent been able to find the op_server.pl or op_server.cfg files.

has anyone else had this trouble or any idea where these files would be....it also says that in the .cfg files /var/www/html/panel/html should be referenced. i dont even see an html directory inside /var/www. could asterisk have not installed correctly or could these have been changed? thanks for any help anyone can give.
Title: Re: Problem using Asterisk
Post by: teedge77 on September 09, 2007, 08:32:12 pm
well....found em....now just gotta figure out editing them....


/var/www/pluto-admin/amp/panel/op_server.pl
/var/www/pluto-admin/amp/panel/op_server.cfg
Title: Re: Problem using Asterisk
Post by: teedge77 on September 09, 2007, 08:46:04 pm
ok....it turns out the op_server.pl wasnt run first. is there a way to set this to run at boot or should it be set already and i need to change something?