LinuxMCE Forums

General => Installation issues => Topic started by: Garbui on August 08, 2017, 08:29:44 am

Title: Linuxmce as a secondary Z-Wave controller
Post by: Garbui on August 08, 2017, 08:29:44 am

Hi all,
I am attempting to configure my core as a secondary controller to my Vera 3 z-wave controller. Currently my Vera 3 system is stable and functional and currently consists of lighting control but will shortly be a couple of door locks. My preferance is to maintain the Vera 3 as the primary for the time being given its stability, door lock compatibility, geofencing and Alexa integration.

I am using an Aeonlabs S2 usb inclusion controller in my core to bridge the controllers.

So far i have tried to initiate suc/sis mode following wiki instructions with no luck and trasferring the Vera 3 configuration to the S2 controller and initiate download with both Sarah and diretly through webadmin.

I would like to get to a similiar setup as JaseP and have followed his steps identified in several alebit older forum posts. Is there any active users who are using this same setup that could assist?

Thanks
Garath

Title: Re: Linuxmce as a secondary Z-Wave controller
Post by: pointman87 on August 23, 2017, 03:14:16 pm

Also interested in this.

BR Daniel