LinuxMCE Forums

General => Users => Topic started by: slampt on February 05, 2011, 08:29:48 am

Title: Dead Z-Wave module
Post by: slampt on February 05, 2011, 08:29:48 am
Hey All,

I have a faulty z-wave module that I wish to remove from my network however un-pairing doesn't work. Is there a way to permanently remove the dead z-wave module without resetting the stick and starting again.

Cheers
Slampt
Title: Re: Dead Z-Wave module
Post by: totallymaxed on February 05, 2011, 09:23:10 am
Hey All,

I have a faulty z-wave module that I wish to remove from my network however un-pairing doesn't work. Is there a way to permanently remove the dead z-wave module without resetting the stick and starting again.

Cheers
Slampt

Have you tried factory resetting the module in question?

Andrew
Title: Re: Dead Z-Wave module
Post by: slampt on February 05, 2011, 09:31:33 am
Sure did, still no joy.
Also FWIW I only paired it once but it added 3 nodes for the 1 device. Which I can't remove at all.
I am hoping there is a way to remove dead nodes without reseting and starting again.  It was a bitch to get the minimote paired as an inclusion controller with the Stick.

Cheers
Slampt
Title: Re: Dead Z-Wave module
Post by: hari on February 05, 2011, 05:06:16 pm
i need to add some code for that..
br Hari
Title: Re: Dead Z-Wave module
Post by: slampt on February 06, 2011, 04:11:53 pm
Hey Hari,

Is it something you are planning on adding at a later stage?
If not I may take a look into it.

Cheers
Slampt
Title: Re: Dead Z-Wave module
Post by: slampt on February 16, 2011, 12:40:33 am
*bump*
Just wanted to get Hari's attention, I don't want to start poking around if you already have plans to implement this.

Cheers
Slampt