LinuxMCE Forums

General => Users => Topic started by: crisis90 on November 23, 2010, 01:24:05 pm

Title: PXE boot MD not working
Post by: crisis90 on November 23, 2010, 01:24:05 pm
Hi all,

I finally got my Foxconn NT330i MD to PXE boot.


However after the boot process the kubuntu bar will appear, move twice and then the MD doesn't do anything anymore.
Do you have any suggestions on what the problem could be?
Thanks in advance!

Regards,

Chris
Title: Re: PXE boot MD not working
Post by: bongowongo on November 23, 2010, 02:38:18 pm
Sounds like unsupported NIC
Look in the wiki.
Title: Re: PXE boot MD not working
Post by: crisis90 on November 23, 2010, 06:13:40 pm
already followed everything in the wiki that how i got the NIC recognized in the first place. I then had some problems with PXE boot, this was solved too. I can't quite seem to figure out what the problem could be now...
Title: Re: PXE boot MD not working
Post by: purps on November 23, 2010, 06:40:17 pm
If you've got a spare hard disk and CD drive kicking about, try and install an ordinary kubuntu 0810 desktop on it, see what happens. I'm not suggesting this as a fix, but it might help diagnose the problem.

Looks like a very nice unit by the way!
Title: Re: PXE boot MD not working
Post by: Beeker on November 24, 2010, 10:57:07 am
Hey Chris
How did you get it to boot I brought one recently and gave up on it as I followed all the wikis and was still getting a kernel panic

Regards
Beeker
Title: Re: PXE boot MD not working
Post by: crisis90 on November 24, 2010, 08:04:18 pm
ordinary kubuntu 8.10 runs like heaven.

attempt to kill init: see wiki or read my posts in the forum..

still not working here as it still hangs in splah menu
Title: Re: PXE boot MD not working
Post by: daballiemo on November 27, 2010, 12:21:17 pm
I received my 330i yesterday and got it up and working  ;D

Please find my notes in http://wiki.linuxmce.org/index.php/Foxconn_nT330i (http://wiki.linuxmce.org/index.php/Foxconn_nT330i) Including how to overcome the kernel panic and splash screen lock up.

Now the only thing is how to get acceleration up and running as HD is "no go" yet.

rgds

Han
Title: Re: PXE boot MD not working
Post by: PaulH on November 27, 2010, 03:31:55 pm
Hi Chris90,
How long did you wait?
My initial setup took long time too. I learned to be patient with LMCE since then. Just let it be for a while, walk away for few hours (i did it overnight but I am sure its much shorter than that).
Also remember, system boots to VGA. If your set up different than VGA, follow wiki for holding down a key which I forget now. If you get a kernal panic at the end then, it's a different matter. This is just my $0.02
PaulH