LinuxMCE Forums
Archive => Archive => Pluto Main General Issues => Topic started by: archived on December 19, 2006, 12:41:17 pm
-
I would add new GSD device for control Light system, but I can't find info!
when I add a new device under Pluto Admin\Generic Serial Device I add new manufacter, but If I select interface there isn't new device. It work if I select AV, why?
There is a guide for add GSD parameter?
thank you
-
Hi serra82
have a look at this :
http://plutohome.com/wiki/index.php/GSD_to_drive_a_Weeder_I/O_WTDIO-M
It's a wiki page, describing how to set up a GSD to drive an external device that controls some lights.
HTH
Marco
-
thank you for the reply,
but my problem is the connection with my device over ethernet.
I'have create a new GSD, insert IP and port but nothing is send to the device :-(
How the core can comunicate with it?
-
thank you for the reply,
but my problem is the connection with my device over ethernet.
I'have create a new GSD, insert IP and port but nothing is send to the device :-(
How the core can comunicate with it?
Hi,
then take a look at existing ip gsd devices (ip cameras). Add them to system and explore their Ruby GSD code. Also search for GSD on Wiki. It might help you a lot.
HTH,
Regards,
Rob.
-
thank you for help!
I have added new GSD and the comunication work!But I still have some problems!
I would like to create an interface for light and temperature control, when I add a light switch controlled via myGSD the command from light isn't send to myGSD, why? Should I add an interceptor?
How works CM11a? I have two ethernet modules with some rele and a temperature sensor, I would like to control one with GSD and one with DCE into microcontroller, Who can help me?
thank you
Andrea