Print Page - Setting up Teliax in LINUXMCE

Title: Setting up Teliax in LINUXMCE
Post by: Marper on January 31, 2009, 09:17:06 PM

I've tried repeatedly to get this setup. I've used the setup wizard as well as tried to manually. Under devices - Phone Lines - it displays as registered.. However, when I try to make a call from MD I get msg, "Your call cannot be completed as dialed". I know I'm dialing the number correctly.

Q: does this problem point to not having the outgoing line setup correctly ?

Q: Should I use the configuration for AMP, SIP or AIX from the Teliax support site ?

Title: Re: Setting up Teliax in LINUXMCE
Post by: Marper on January 31, 2009, 09:50:20 PM

Did not dial "9" to get an outside line. Can I change the requirement to use 9 for dialing out ? Where do I make that change ?

Title: Re: Setting up Teliax in LINUXMCE
Post by: tkmedia on January 31, 2009, 11:28:23 PM

The Teliax is IAX by default, however i was able to add a sip trunk later.

Tim

Title: Re: Setting up Teliax in LINUXMCE
Post by: Marper on February 01, 2009, 01:59:37 AM

Thanks - got it working.

Is there a wiki on changing the Ring Tone ? Or should I be able to add my own voice and dialoge to the system ?

LinuxMCE Forums

General => Installation issues => Topic started by: Marper on January 31, 2009, 09:17:06 PM