Supposedly when you setup LMCE Teliax is among the supported carriers that LMCE will setup automatically. Well mine doesn't work. I signed on to the Teliax website and it confirms that my account is active. I ran a couple of commands and the output was:
dcerouter_93254:/home/linuxmce# asterisk -r
=========================================================================
Connected to Asterisk 1.4.10 currently running on dcerouter (pid = 8219)
dcerouterCLI> iax2 show peers
Name/Username Host Mask Port Status
teliax1 (Unspecified) (S) 0.0.0.0 4569 Unmonitored
teliax-out/sinc 74.201.8.23 (S) 255.255.255.255 4569 OK (28 ms)
2 iax2 peers [1 online, 0 offline, 1 unmonitored]
dcerouterCLI> iax2 show registry
Host dnsmgr Username Perceived Refresh State
74.201.8.23:4569 N sincityhar <unregistered> 60 Rejected
dcerouter*CLI>
Not sure if this helps or not. I could really use some help from anyone out there familiar with setting this up on a LMCE box. Your time would be greatly appreciated.
Also when I try to make a call I get "all circuits are busy" it also shows an error that reads: Call dropped. Reason: Facility not subscribed
Can anyone help me make sense of this?
I used the teliax template fro use with voicepulse i have had various issues so i may be able to help.
You can check your trunk settings in freepbx. Under advanced_>configuration phones setup.
Review your docs for your voip ... stop by chat if you like, i'll try to help there.
Tim
Hi TK,
For phone setting using teliax, I setup a SIP based trunk, is that correct ? Also, I downloaded the guide from the teliax site and put in all of the peer and user settings however, when I try to dial, I get the message "Your call cannot be completed as dialed". Do you have any idea what I'm missing ?
Are you dialing 9 to get an outside line?
Tim
No I'm not ddialing 9 - Should I be ?
Yes
Dial 9 to get outside line
Tim