Print Page - GC-SP1 Question

Title: GC-SP1 Question
Post by: rdmustang on October 10, 2008, 08:06:29 PM

I know this question doesn't directly relate to LMCE but it is somewhat related.

Does anyone know how to use the GC-SP1 to determine whether a device is turned on (like my receiver, tv, projector, etc)? I've asked Global Cache but they won't respond. I also asked SmartHome and they didn't know.

Title: Re: GC-SP1 Question
Post by: tschak909 on October 10, 2008, 08:12:07 PM

any time a signal is found, the contacts are closed. You can use this to trigger events from a generic sensor point of view.

-Thom

Title: Re: GC-SP1 Question
Post by: rdmustang on October 11, 2008, 05:14:21 AM

I understand the concept of how it works. What I don't understand is how to get a low voltage output from a device like a receiver, tv, or projector. Global Cache says to use a "wall adapter" but I can't figure out what that is, GC won't respond to inquiries and SmartHome doesn't know either.

What would I hook the wires up to on the GC-SP1?

Thanks!

LinuxMCE Forums

General => Users => Topic started by: rdmustang on October 10, 2008, 08:06:29 PM