I am sure this is probably a simple question, but I have completed the Insteon PLM configuration all except the COM Port setting.
I have no serial port on the current core, but I do have a GC100 with a serial port.
How do I get the Insteon PLM setup to use the GC100 serial port?
Any help would be greatly appreciated.
Leo
You should have an "/dev/tty_S_##_#" to choose, where ## is the device number of the gc100 and the #'th serial port.
Zaerc,
Thanks, I found it as you said. I knew it had to be simple!
Now, I can complete the Insteon setup. I have been putting it off since my previous 4 failed attempts to follow the Wiki setup. Thanks to williammanda's updates the the Setting Up PLM Template on the Wiki, I was able to complete it to this point.
Hopefully, getting all my Insteon switches setup won't be too difficult.
Leo
pcbastard,
Did you finish your insteon set up?.
I have a GC100 also connected to my 2412S and I have some issues sending command out to the switches have you experienced something alike?.